Instructions that accompany CleanTrax

Handling and Preparation

DO NOT open the bottle until you are ready to use it.

Store the bottle in a refrigerator or a cool dry place.  DO NOT leave it in the sun or expose it to heat.

Before use, remove horse shoes or anything else on the hoof.  If the horse is going to be shod, clean and prepare the hoof for shoeing first.

CleanTrax is safe to use on open wounds and will not affect the quality, color, or appearance of the skin or hair.

Directions for Use

1.  Clean the hoof; remove and wash away excess dirt and debris.

2.  Mix the entire contents of a bottle of CleanTrax into one gallon of room temperature tap water.

3.  Pour all the CleanTrax solution into a CleanTrax hoof boot or a reinforced plastic bag.

4.  Immerse the hoof completely into the CleanTrax solution.  (If a bag is used, pull the top of the bag up above the knee and tie or tape it closed.)

5.  Soak the hoof for 45 minutes.  If the infection is bad or recurring, extend the soak time to 60 minutes.

Note:  CleanTrax solution is good for a total of 90 minutes, so you can use the same solution to soak two hoofs consecutively.  When you are finished soaking, the solution can be poured or sprayed on the stall floor, trailer mats and trimming area to eliminate fungal spores.

6.  After soaking, do not rinse or dry the hoof.  Put empty plastic bag over the hoof and close the top.  Allow the vapors to penetrate for 45 minutes.

7.  If the infections is bad or recurring, repeat the treatment in 2 to 4 weeks.

8.  To protect the horse's feet and keep them free of infection, every 3 to 4 months use on bottle of CleanTrax to soak each hoof for 20 minutes.

Precautions:  The powder and solution are for external use only.  Keep away from small children.  The solution will damage colored fabrics.